8. Test your switch setting by cycling through the three positions for the G switch (up, center, down). If set correctly, the ON/OFF setting should change from “OFF” for the up position to “ON” for the mid and down positions. “ON” simply means that the transmitter enables elevator mix-in for the mid and down positions I wish to assign a switch as follows: Position 1: All surfaces act as ailerons, all controlled by right stick. Position 2: 2 surfaces act as ailerons (controlled by stick) and 2 surfaces act as flapes (not moving with stick, set at ~15% bank). Position 3: same as pos-2 with different percentage of bank. All help will be apriciated.
The first episode below presents how to prepare the transmitter for the CGY760R FBL system. The video was recorded with a Futaba T18SZ transmitter, but Hamish explains everything, so everybody can prepare any Futaba transmitters with an average understanding on the transmitter owned. This video is about 9 minutes long, but it is not boring at all.
41. Set up twin aileron servos: see p. 44. Set up twin elevator servos: see p. 50. Set up programmable mixes to meet your specific needs: see p. 54. www.futaba-rc.com\faq\faq-9c.html for all triple rates on a single switch, etc. Page 38: Timer Submenu
Re: 4PM Set up for Dual ESC & MOA. i would say for your 4pm set up just go ahead and.use the 2pm set up im sure jt wont cause a problem but after 5pm you might want a hotter set up as you might want to blow off some steam left over from the work day. sorry if this dosent help lol good luck. 01-21-2021, 11:07 AM. # 7.
All you have to do is designate a second channel in the function menu to elevator. All trims and other elevator functions will follow to the second channel and there is no need for further programming or reprogramming other than setting up subtrim and end points on the new channel. Reply Like. 06-06-2018, 08:32 AM. # 11. iQRWSi.
  • pavl68km16.pages.dev/40
  • pavl68km16.pages.dev/83
  • pavl68km16.pages.dev/199
  • pavl68km16.pages.dev/429
  • pavl68km16.pages.dev/419
  • pavl68km16.pages.dev/560
  • pavl68km16.pages.dev/134
  • pavl68km16.pages.dev/515

    • how to set up futaba transmitter